BLADDER

TECHNICAL PARAMETERS

• the entire rubber pressure water bag with a rubber vulcanization molding
• Under pressure, can be fully inflated, without secondary pressure, to ensure that the conveyor belt curing machine in the belt joint and repair process evenly under pressure, the test safety pressure range of 3Mpa or less, fully meet the requirements of curing machine joints
• the rubber pressure produced by our company is only a quarter of the weight of the old water pressure plate, and because of the expansion of the increase in the installation of equipment on both sides of the fixed bolt only gently wrench with a wrench
• Rubber pressure water bag around only 2 cm border, relative to the old water pressure plate more than 5 cm border, limited to increase the pressure area, thereby improving the quality of curing
• If the vulcanizer pressure beam is separated, it is necessary to put a piece of wood on both sides of the pressure water bag, play the role of protecting the pressure water bag
  
  

  Model               (mm)	Dimension for 18° (mm)	Dimension for 90° (mm)	Pressure (Mpa)	Weight       (kg)	Expansive degree       (mm)
  1000*830	1220*830*20	1160*830*20	2.0-3.0	20	10-40
  1200*830	1420*830*20	1360*830*20	2.0-3.0	23	10-40
  1400*830	1620*830*20	1560*830*20	2.0-3.0	26	10-40
  1600*830	1820*830*20	1760*830*20	2.0-3.0	29	10-40
  1800*830	2020*830*20	1960*830*20	2.0-3.0	32	10-40

  Model(mm)	Dimension for 18° (mm)	Dimension for 90° (mm)	Pressure (Mpa)	Weight          (kg)	Expansive degree       (mm)
  1000*1000	1220*1000*20	1160*1000*20	2.0-3.0	20	10-40
  1200*1000	1420*1000*20	1360*1000*20	2.0-3.0	23	10-40
  1400*1000	1620*1000*20	1560*1000*20	2.0-3.0	26	10-40
  1600*1000	1820*1000*20	1760*1000*20	2.0-3.0	29	10-40
  1800*1000	2020*1000*20	1960*1000*20	2.0-3.0	32	10-40